E-
29
GETTING ST
AR
TED
PLA
YB
A
C
K
RECORDING
ADDITIONAL
INFORMA
TION
ENGLISH
.................................................. ADDITIONAL INFORMATION
Display Messages
Can’t Copy
Digital recording cannot be performed. (See “SCMS
copy protection” on page 28.)
Check Disc
This is displayed when the recorder stops after reading
disc information, while performing an erase procedure,
finalization, or OPC. If this occurs, the disc may be dirty
or possibly even damaged. Remove the disc and
inspect it.
Close
The disc tray is being closed.
Data Track
This is displayed when the data track is played back.
Disc Full
Recording is not possible because there is no blank
space remaining on the disc.
Erase ALL?
Erases all tracks on a CD-RW disc.
If you want to erase all tracks, press
w
/
d
(
w
on the
remote).
Erase DISC?
Erases all of the information a CD-RW disc.
If you want to erase all of the information, press
w
/
d
(
w
on the remote).
Erase LAST?
Erases the last track on a CD-RW disc.
If you want to erase the last track, press
w
/
d
(
w
on the
remote).
Erase TOC?
Erases the TOC (Table Of Contents) on a CD-RW disc.
If you want to erase the TOC, press
w
/
d
(
w
on the
remote).
Finalize?
Finalizes the CD.
If you want to finalize the disc, press
w
/
d
(
w
on the
remote).
Finalized
Recording has been attempted on a CD-RW disc that
has already been finalized.
Finalizing
During the finalization process, the TOC (Table Of
Contents) is being written onto the disc.
New Disc
The disc in the disc tray is either a new CD-R or CD-RW
disc or a CD-RW disc that has been erased using the
Erase ALL or Erase DISC function.
No Disc
There is no disc on the disc tray.
No Input
The digital input is selected, but the connections are not
correct, or the digital signal is not being output from the
source device. Please check all cabling, and the status
of the source device.
Not Audio
The inserted disc is not an audio CD-R or CD-RW disc.
This is displayed when REC, FINALIZE, or ERASE is
pressed.
OPC Adjust
Adjustments performed when OPC (Optimum Power
Calibration) optimizes the laser power to the reflectivity
of the disc. Some time is required to complete these
automatic adjustments.
Open
The disc tray is being opened.
Reading
When the recorder is turned on or a disc is loaded, the
recorder reads the format of the disc loaded in the
recorder.
Standby
This unit has been put in the standby mode.
TEXT Save?
This is displayed if you attempt to open the disc tray
without performing finalization after CD TEXT data is
copied or edited.
Track Full
Recording is not possible because the maximum
number of 99 tracks has already been recorded on the
disc.
Wait
The recorder has been put in the stop mode from the
record mode and information is being written to the PMA
(Program Memory Area). Never turn the power off when
this is displayed.
