NOTES ABOUT HANDLING COMPACT DISCS
15
NOTES ABOUT THE REMOTE CONTROL TRANSMITTER
●
This compact-disc player is designed only for playing of
compact discs bearing the
mark. Never attempt to
load any other type of disc into the unit.
The unit will also play 3-inch (8-cm) compact discs.
●
To remove a disc from its storage case, open the case and
then press down at the center; with a finger through the
center hole and the outer edges held as shown in the
illustration, lift the disc out carefully.
●
Always handle the disc with care so that its surface is not
scratched.
●
Compact discs are not subjected to wear during play, but
damage to the disc surface when the disc is being handled
can adversely affect the disc's play.
●
Compact discs are not affected by small particles of dust or
fingerprints on their playing surface, but even so they
should be kept clean. Wipe by using a clean, dry cloth. Do
not wipe with a circular motion; wipe straight outward from
the center.
●
Do not try to clean the disc’s surface by using any type of
disc cleaner, record spray, anti-static spray or liquid, or any
other chemical-based liquid, because such substances
might irreparably damage the disc’s surface.
●
Do not expose discs to direct sunlight, high temperature or
high humidity for a long period of time, because these might
warp or otherwise damage the disc.
To play a 3-inch (8-cm) CD
Place it in the inner recessed area of the disc tray. Do not put
a normal (5-inch/12-cm) CD on top of a 3-inch CD.
Battery installation
Battery replacement
If you find that the remote control transmitter must be used
closer to the main unit, the batteries are weak. Replace both
batteries with new ones.
Notes
●
Use only AA,R6,UM-3 batteries for replacement.
●
Be sure the polarities are correct. (See the illustration
inside the battery compartment.)
●
Remove the batteries if the remote control transmitter will
not be used for an extended period of time.
●
If batteries leak, dispose of them immediately. Avoid
touching the leaked material or letting it come in contact
with clothing, etc. Clean the battery compartment
thoroughly before installing new batteries.
Remote control transmitter operation range
Notes
●
There should be no large obstacles between the remote
control transmitter and the main unit.
●
If the remote control sensor is directly illuminated by strong
lighting (especially an inverter type of fluorescent lamp etc.),
it might cause the remote control transmitter to not work
correctly. In this case, reposition the main unit to avoid
direct lightening.
2
1
3
30
°
30
°
,,
,
,
,
NO!
Remote control
sensor
Within approximately
7 m (23 feet)