Yamaha AR190 2012, Руководство владельца/оператора

Страница: 44 / 142

Instrument operation
38
3-Backlighting
The brightness level of the LCD can be ad-
justed.
To adjust the brightness:
(1) Push the M button to decrease the bright-
ness or push the T button to increase the
brightness. The brightness changes each
time a button is pushed.
(2) Wait approximately 8 seconds or push
the M button and T button simultaneously
to save the setting and return to the sys-
tem menu.
4-Read Param
The conditions or status of the boat can be
checked. Of the 11 items that can be shown in
the normal display of the LCD, the following 8
items can be checked.
●
Speed: Boat speed
●
Eng RPM: Engine speed
●
Fuel Lvl: Fuel level
●
Voltage: Battery voltage
●
Aux Volt: Auxiliary battery voltage
●
Hrs: Engine hours
●
Stbd Fuel: Fuel consumption per hour
●
Port Fuel: “-” will be shown because this
item is not applicable.
To display an item:
(1) Push the M button to scroll down through
the items or push the T button to scroll up.
(2) Push the M button and T button simulta-
neously to return to the system menu.
5-Instr. Diag
The meters can be tested and the conditions
of the meters can be checked.
The following 5 tests and checks can be car-
ried out.
1-Gauge Test
2-LCD Test
3-Analog Inputs
4-Binary Inputs
5-Binary Outputs
To carry out the gauge test:
(1) Push the M button or T button to select
“Gauge Test”, and then push the M but-
ton and T button simultaneously.
(2) Check that the needles of the meters
move according to the initial operation
when the engine is started.
(3) Push the M button to stop the test and re-
turn to the “Instr. Diag” display.
To carry out the LCD test:
(1) Push the M button or T button to select
“LCD Test”, and then push the M button
and T button simultaneously.
ENTER
BACKLIGHTING
Exit
Speed
Eng RPM 0 mph
1350 RPM
SportsBoat.book Page 38 Monday, October 31, 2011 4:12 PM