Yamaha AQUA CRUISE, Руководство пользователя

Страница: 12 / 14

19 20
If the AQUA CRUISE does not work:
1. Check the battery is fully charged, if in doubt of
battery state, recharge the battery until Charger
indicates full charged.
2. Make sure the rechargeable battery connector is
connected.
3. Make sure the Master Switch is in the 'ON' position.
4. Make sure the battery compartment is dry.
5. Make sure the Propeller is not blocked.
Blocked Propeller
If the propeller becomes blocked, it will be necessary to
open the Grille to remove the obstruction. Open the grilles
to remove obstruction:
1. Remove AQUA CRUISE from water and dry completely.
5. Unscrew the propeller nut using an M6 socket
(See Fig.16).
6. Remove the washer, propeller and the drive pin.
(See Fig.16)
7. Remove any blockage.
8. Replace drive pin, propeller and the washer, and
reattach propeller nut.
9. Replace Rear Grille.
Sand or Grit on Seals
Ensure that sand/grit does not get on the seals as correct
maintenance and care is essential. To remove sand or grit
from the seals, rinse the seals in fresh water and apply fresh
lubricant. If there is sand inside the Battery Housing, gently
brush the sand from the unit taking care not to scratch the
sealing surfaces.
2. Make sure the master switch is in the 'OFF' position.
3. Remove the battery - see page 11-12, step 1-8.
4. Unscrew rear grille (See Fig.15 ).
Fig.16
nut
washer
drive pin
Repairing the Inflatable
A repair kit is included in case the inflatable is accidentally
punctured to repair:
1. Locate the puncture - this can be done by inflating the
inflatable and looking for air bubbles.
2. Deflate the inflatble product.
3. Clean area throughly where repair is to be made. Make
sure it is completely clean and dry.
4. Flatten the surface around the punctured area.
5. Cut patch material to size.
6. Use only enough liquid cement to wet the back to repair
area.
7. Press tightly to repair area and let it dry.
8. Do not inflate for 12 hours.
9. Inflate the inflatable and check there is no air leakage
before use.
Maintaining Battery Door Seal
Always keep the Battery Door Seal clean and well
lubricated with silicone grease which can be purchased
from your local hardware store.