14
En
TROUBLESHOOTING
The volume level
cannot be increased,
or the sound is
distorted.
The component connected to the LINE 2
PB/REC jacks of this unit is turned off.
Turn on the power of the component.
—
The sound is
degraded when
listening with
headphones
connected to a CD
player connected to
this unit.
This unit has been set to standby mode.
Turn on the power of this unit.
The BASS, TREBLE
and BALANCE
settings do not
applied to the sound.
The PURE DIRECT function is turned on.
The PURE DIRECT function must be turned off to
apply these settings to the sound.
The remote control
does not work nor
function properly.
Wrong distance or angle.
The remote control will function within a maximum
range of 6 m and no more than 30 degrees off-axis
from the front panel.
Direct sunlight or lighting (from an
inverter type of fluorescent lamp, etc.) is
striking the remote control sensor of this
unit.
Reposition this unit.
—
The batteries are weak.
Replace all batteries.
Your tuner and/or CD
player cannot be
operated with the
remote control.
The remote control does not support the
tuner and/or CD player.
Refer to the owner’s manual supplied with the tuner
and/or CD palyer.
—
“OVER HEAT”
appears on the front
panel display.
This unit has become too hot.
Make sure the openings on the top panel are not
blocked.
—
“CHECK SP” appears
on the front panel
display.
Speaker cables got shorted out.
Twist bare wires of speaker cables firmly, and then
connect to this unit and speakers properly.
—
Problem
Cause
Remedy
See
page