6-6
CARBURETOR
CARB
NOTE:
NOTE:
4 Nm (0.4 m
kg)
NOTE:
1. Adjust:
TPS (throttle position sensor) position
Adjustment steps:
Turn the main switch to ”ON”.
Disconnect the TPS (throttle position sensor)
coupler.
Reconnect the TPS (throttle position sensor)
coupler.
When the above procedure is commenced, the
machine switches to TPS (throttle position sen-
sor) adjustment mode.
Loosen the TPS (throttle position sensor) screws
1 .
Adjust the TPS (throttle position sensor) posi-
tion.
The angle of the TPS (throttle position sensor) is
shown on the tachometer.
Adjust the angle of the TPS (throttle position sen-
sor) as appropriate as shown below.
When the angle is correct, the tachometer
reads 4,000 rpm.
When the angle is too wide, the tachometer
reads 8,000 rpm.
When the angle is too narrow, the tachome-
ter reads 1,000 rpm.
After adjusting the angle, tighten the TPS
(throttle position sensor) screws.
To return to normal mode, start the engine or reset
the main switch.
Содержание 4TX-AE1
