Beware of
sharp corners
when servicing
TROUBLESHOOTING
Drive Pin In Position
33
34
35
Unit does not function
If the Propeller does not start when the trigger(s) is/are pressed, make sure:
1. The Master Switch is ON.
2. The Battery Pod is fully charged. (see page 7, Charging The Battery)
3. The battery compartment is dry.
Blocked Propeller
If the Propeller becomes blocked, it will be necessary to open the Protective Grilles to remove the obstacle.
UNDER NORMAL USE the grilles must not be opened.
NEVER turn the propeller ON when it is blocked; it would cause serious damage to the gear box.
Opening the Grilles to Remove Obstruction
WARNING
Crushing / Cutting Hazard
Before opening the grille for maintenance purposes, make sure the master switch is in off position, and the battery is disconnected.
1. Take the Seascooter out from the water.
2. Make sure the Master Switch is in the OFF position.
3. Disconnect and remove the Battery Pod - see page 8, step 1 - 9.
4. Unscrew the five Rear Grille screws to remove the rear grille. (see Fig. 33)
5. While holding the Propeller, use an M6 socket wrench to remove the nut from the Propeller shaft as shown in Fig. 34.
6. Slide the Propeller off the shaft, taking care not to lose the drive pin or washers.
7. Remove the blockage from the Propeller or Propeller Shaft.
8. Replace the drive pin (if removed), see Fig. 35, and Propeller. Turn the Propeller slowly until you locate the pin and push the Propeller fully on.
13
