Yamaha 2011 WR450FA, Руководство по эксплуатации для владельца

Страница: 29 / 230

1-19
STARTING AND BREAK-IN
The engine fails to start
Pull the hot starter lever all the way
out and while holding the lever, kick
the kickstarter crank 10 to 20 times to
clear the engine. Then, restart the en-
gine. Refer to "Restarting an engine
after a fall".
Observe the following break-in
procedures during initial operation
to ensure optimum performance
and avoid engine damage.
BREAK-IN PROCEDURES
1. Before starting the engine, fill the
fuel tank with the fuel.
2. Perform the pre-operation checks
on the machine.
3. Start and warm up the engine.
Check the idle speed, and check
the operation of the controls and
the engine stop switch. Then, re-
start the engine and check its op-
eration within no more than 5
minutes after it is restarted.
4. Operate the machine in the lower
gears at moderate throttle open-
ings for five to eight minutes.
5. Check how the engine runs when
the machine is ridden with the
throttle 1/4 to 1/2 open (low to me-
dium speed) for about one hour.
6. Restart the engine and check the
operation of the machine through-
out its entire operating range. Re-
start the machine and operate it
for about 10 to 15 more minutes.
After the break-in or before each
ride, you must check the entire ma-
chine for loose fittings and fasten-
ers as per "TORQUE-CHECK
POINTS". Tighten all such fasten-
ers as required.
Thro
ttle
grip
op-
era-
tion*
Cold
start-
er
knob
Hot
start-
er le-
ver
St
ar
ti
n
g
a
c
ol
d
e
n
gi
n
e
Air tempera-
ture = less
than 5 °C (41
°F)
Ope
n 3
or 4
time
s
ON OFF
Air tempera-
ture = more
than 5 °C (41
°F)
Non
e
ON OFF
Air tempera-
ture (normal
temperature)
= between 5
°C (41 °F)
and 25 °C
(77 °F)
Non
e
ON/
OFF
OFF
Air tempera-
ture = more
than 25 °C
(77 °F)
Non
e
OFF OFF
Starting an en-
gine after a long
period of time
Non
e
ON OFF
Restarting a
warm engine Non
e
OFF ON
Restarting an en-
gine after a fall Non
e
OFF ON
* Operate the throttle grip before kick
starting.