3 - 22
CHK
ADJ
MEASURING THE COMPRESSION PRESSURE
7. Measure:
•
compression pressure
Out of specification
→
Refer to steps (c)
and (d).
▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼ ▼▼▼
▼
▼▼▼
a. Set the main switch to
“
ON
”
.
b. With the throttle wide open, crank the
engine until the reading on the compression
gauge stabilizes.
WARNING
_
To prevent sparking, ground the spark plug
lead before cranking the engine.
c. If the compression pressure is above the
maximum specification, check the cylinder
head, valve surfaces, and piston crown for
carbon deposits.
Carbon deposits
→
Eliminate.
d. If the compression pressure is below the
minimum specification, pour a teaspoonful
engine of oil into the spark plug bore and
measure again.
Refer to the following table.
▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲ ▲▲▲
▲
▲▲▲
Compression pressure (at sea
level)
Minimum
1,100 kPa
(11.0 kg/cm
2
, 156.5 psi)
Standard
1,400 kPa
(14.0 kg/cm
2
, 199.1 psi)
Maximum
1,650 kPa
(16.5 kg/cm
2
, 234.7 psi)
Compression pressure
(with oil applied into the cylinder)
Reading
Diagnosis
Higher than with-
out oil
Piston wear or
damage
→
Repair.
Same as without
oil
Piston rings,
valves, cylinder
head gasket or pis-
ton possibly defec-
tive
→
Repair.
Downloaded
from www.ScooterTime.net