Yamaha 2004 Rhino 660 YXR660FAS, Руководство по обслуживанию, Страница: 280 / 421

7 - 29
DRIV
REAR CONSTANT VELOCITY JOINTS, FINAL DRIVE
GEAR AND DRIVE SHAFT
6) Round off the hundredth digit and select the
appropriate shim(s).
In the example above, the calculated num-
ber is 0.48. The chart instructs you to round
off 8 to 10 at the hundredth place.
Thus, the shim thickness is 0.50 mm.
Shims are supplied in the following thick-
nesses.
▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲ ▲▲▲ ▲ ▲▲▲
Selecting the thrust washer
1. Measure:
• ring gear thrust clearance “C”
▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼ ▼▼▼ ▼ ▼▼▼
a. Place four pieces of Plastigauge
®
between
the originally fitted thrust washer and the
ring gear.
b. Install the final gear case assembly and
tighten the bolts to specification.
NOTE:
Do not turn the drive pinion gear and ring gear
when measuring the clearance with Plasti-
gauge
®
.
Hundredths Rounded value
0, 1, 2 0
3, 4, 5, 6, 7 5
8, 9 10
Ring gear shim
Thickness (mm)
0.25 0.30 0.35
0.40 0.45 0.50
T
R
.
.
M8 bolts (ring gear bearing hous-
ing)
23 Nm (2.3 m · kg, 17 ft · lb)
M10 bolts (ring gear bearing
housing)
40 Nm (4.0 m · kg, 29 ft · lb)
“C”