5
6.
How to use
1) Wipe the base and the opposite oil supply port base
with a clean waste cloth.
2) Adjust the base groove to the oil supply port base and
set it securely by sliding.
Note that oil leakage may occur if this set status is
incomplete.
3) Tighten the check valve. If the check valve is loose,
the pressure cannot be increased. (Fig. 5)
4) Step on the footboard so as not to move the oil tank
and operate the handle up/down slowly to supply oil.
(Fig. 6)
5) After completion of the oil supply, loosen the check
valve to bleed the internal pressure of the pump and
hose. Then, remove the base from the oil supply port
base.
CAUTION
If the base is removed from the oil supply port base
before the check valve is loosened, oil will be
discharged from the pump and hose, thereby
contaminating the surroundings.
6) After completion of lubrication for all positions,
loosen the check valve to bleed the internal
pressure of the pump and hose, and hang the base
on the base hanger without being contaminated.
(Fig. 7)
CAUTION
- When operating the handle, do not insert the hand into a clearance between the handle
and the handle stopper. An unexpected injury may be caused by nipping.
Fig.7
Fig.6
Fig.5