10
6.3
Installation
For installation, see [Exploded View] on the separate sheet and install in the reverse order of disassembly.
-
Dab lubricant onto the wiper and install it into the pump body.
[Fig.6.9]
- Apply lubricant to the packing and install it into the pump
body. [Fig.6.9]
(See Section “9. Instructions for applying lubrication)
- Attach the ring and O ring onto one side. [Fig.6.9]
＜
NOTE
＞
- Be sure to attach the ring prior to the O ring.
- Attach the bush to the diaphragm and attach the cushion to
the center rod, and insert these parts into the body.
[Fig.6.10]
＜
NOTE
＞
- Be sure to insert the diaphragm into the body until it reaches
the end face of the body securely.
- Attach the ring, O ring and cushion to another side of the body.
Be sure to attach the O ring over the groove. [Fig.6.11]
- While turning the diaphragm, fix it onto the screw of the
center rod. [Fig.6.11]
＜
NOTE
＞
- Be sure to insert the diaphragm into the body until it reaches
the end face of the body securely.
- While pushing the diaphragm toward the outside, attach the
O ring onto the groove. [Fig.6.12]
＜
NOTE
＞
- After attaching the O ring, be sure to push the diaphragm to
the original position. [Fig.6.13]
Tightening torque for horizontal tie rod
4 N
･
m
＜
NOTE
＞
- Make sure that there is not any dust on the seal surface and
that any sealed part cannot be damaged.
- Replace the locking nut with a new one regardless of its
condition.
- Tighten the bolts on a diagonal line with even torque.
- Be sure to fix the bush into the diaphragm securely.
- Be sure to fix the diaphragm into the body until it reaches the
end face of the body securely.
Fig.6.12
Fig.6.11
Fig.6.10
Fig.6.9
Fig.6.13
