IGNITION SYSTEM
PB-2520
EB252
23
4-6 Replacing ignition module (continued)
7. Remove two bolts (Q) and muf
À
er (R).
8. Remove outer fan case and fan referring to “3-2
Disassembling fan and fan case”.
9. Remove four bolts (S) and engine assembly
from inner fan case (T).
10. Remove primary lead terminal (U) from ignition
module(V).
11. Remove two bolts (W), ignition switch terminal
(n1), remove ignition module (V) and two washer
(X) from cylinder.
12. Remove spark plug cap (Y) and spark plug cap
coil from high tension lead.(Refer to 4-4”Replacing
spark plug cap and coil”) Install them on new igni-
tion module (V).
13. Loosely install new ignition module (V), ignition
switch terminal (n1) and two washer with two bolts.
Set air gap (Refer to “4-6 Setting pole shoe air
gaps“). Tighten two bolts (W).
14. Connect primary lead terminal (U) on ignition
module (V).
Q
R
S
T
U
V
W
X
Y
n1
