15
Configuring your system
Fine tune the operation of the control panel to your requirements; advanced
programming for PIRs and door/window contacts.
General settings menu
User PIN code
There are 4 user PIN codes that can be
activated and programmed for use.
1
Use the arrow keys to select the PIN number
for changing.
• Only user 1 is activated with a 0000 factory
default code and the code is displayed with a
(0) indicating it is in use.
• The code can be enabled/disabled by pressing
the
c
key.
2
Press OK when the desired code is selected
and enter a 4-digit number when Enter New
Code is shown.
3
Press OK to confirm and the display will return
to the previous screen where the new code will
be shown.
• User 1 and User 2 are normal user codes used
to regularly arm and disarm the system.
• The Cleaner code can only be used to Away
Arm the system.
• The Temporary code will only disarm the
system once and when Away Arming the
system will automatically erase the code,
perfect for trades people who need access to
your house occasionally.
• Ensure that user1, user 2, cleaner and
temporary codes are all different.
Master PIN code
Programs the PIN code used for accessing the
programming mode.
1
The system asks you for a new PIN number.
Enter a new 4-digit code and press OK.
2
Confirm by keying in your PIN number again.
3
Press OK, if an incorrect code is entered, a
message prompts the previous step.
• The master PIN code is used to protect the
programming mode from unauthorised use.
• The user code and the master code can be
made the same for easier use, however it is
recommended that they are made different
where one responsible person has
programming access only.
Entry time
Enables you to alter the entry delay time.
Options are 0 sec, 10 sec up to 70 sec in 10-
second increments.
1
Use the arrow keys to switch between options.
2
Press OK to confirm.
• 10 seconds is set as factory default.
Exit time
Enables you to alter the exit delay time.
Options are 0 sec, 10 sec up to 70 sec in 10-
second increments.
1
Use the arrow keys to switch between options.
2
Press OK to confirm.
• 10 seconds is set as factory default.
Alarm length
This is for selection of the period of time that
the control unit will sound or not when the alarm
is activated.
1
Press the arrow keys to select the option.
2
Press OK to confirm.
• Siren On is the factory default.
• It is recommended that the siren is left on.
Exit sound
Turns on and off the exit delay audible warning.
1
Press the arrow keys to select the option.
2
Press OK to confirm.
• Exit Sound Low is set as factory default.
• The exit sound can be selected for high or low
volume.
Exit sound
Turns on and off the entry delay audible
warning.
1
Press the arrow keys to select the option.
2
Press OK to confirm.
• Entry Sound Low is set as factory default.
The exit sound can be selected for high or low
volume.
Door chime
Turns on and off the door chime in the control
unit when an entry sensor is activated.
1
Press the arrow keys to select the option.
2
Press OK to confirm
• Door Chime Off is set as factory default.
• The door chime can be set for high or low
volume.
Interference
Sets the interference display
• Radio interference is unlikely, but can effect the
operation of the system. The siren (see Further
siren programming) and the control unit have
the ability to detect interference and give
warnings.
1
Use the arrow keys to choose the setting.
2
Press OK to confirm the setting.
• I.Disp Off is set as factory default.
• When the interference detection is switched off
the unit will not respond at all to interference.
• When the interference detection is switched
