9
Mounting the Keypad:
Battery Saver tab
Wall Fixing
knockouts x2
1
Knock out the fixing holes. Drill holes into the wall
using the fixing holes as a template.
2
Fit wall plugs into the wall and fix back cover with
the screws provided. Fix front of the keypad onto
the back plate.
Mounting the Door Contact
Frame
Door/Window
Gap no more
than 10mm
Magnet
Sensor
Sensor
ale
Y
1
Find a location on the door/window where you
would like the device to be mounted. The sensor
should be on the frame while the magnet should
be on the door/window. Once mounted make sure
the tamper switch spring is fully depressed.
The gap between the magnet and sensor should
be no more than 10mm when closed (maybe
shorter depending upon the actual environment).
Simple test to see whether the magnet is in range
of the sensor: hold the magnet and sensor in
place and then pull them apart. If the sensor LED
lights up it implies the two items are within range.
i
-Mounting using adhesive pads
Clean the mounting surface with a suitable
degreaser agent. Please note that some surface
or environment (i.e. exposure to Sunlight) may be
unsuitable for this mounting method. Please use
screw mounting in these cases.
-Mounting using screws and wall plugs
Loosen the bottom screw and open the door/
window contact. Knock out the holes on the base
as shown. Drill holes into the mounting surface
using the holes in the knockouts on the base as
template. Fit wall plugs (if required) and secure
with the screws provided.
Mounting the Help button
1
Break through the knockouts (where the plastic is
thinner).
2
Using the holes as a template, drill holes in the
surface and insert wall plugs if fixing into plaster or
brick. Screw the rear case to the wall. Replace the
cover and tighten the screw.
Mounting the Smoke
Detector
1
The base has two mounting
slots. Using the slots as a
template, drill holes and
insert the wall plugs if fixing
to plaster. Screw the rear
case to the ceiling using the
screws provided.
2
Replace the main unit onto the bracket.
Mounting the Room Sensor
1
Push tab to the left to open the case. The base
has two mounting slots. Using the slots as a
template, drill holes and insert the wall plugs
if fixing to plaster. Fix the base to the wall with
screws.
2
Replace the main unit onto the base.
Knockouts