10
About your alarm system (default settings)
Each system has 20 free SMS credits, after
which Yale reserves the right to charge for any
additional SMS sent.
i
To change the exit and entry timer, please see
“Controller” -> “Panel Setting”
Home arming is disabled by default. If you need
Home arming function, see page 11.
To change the attributes of individual sensors
(i.e. Burglar attribute where the individual
sensor will instantly alarm when triggered),
please go to “Devices List”, then click on
sensor’s setting.
i
All accessories (except EF-PC)
are pre-set to “entry” attributes.
When the system is first armed, users will have 30
seconds to exit the building. The System will ignore
any sensors triggering in this duration. If the system
is already armed, triggering any sensors will cause
an entry countdown to begin.
EF-PC/EF-PVC’s default setting is “Away only”, i.e.
immediate triggering during full arm and sleep during
home arm. This is done to conserve battery life
When the alarm is triggered, the
system will send an email, push
notification (iOS only) and SMS to
alert the owner.
The network traffic condition will determine how
quickly the user is alerted. There may be noticeable
delay should the third party email/SMS gateway
become congested.
You will be prompted on the app when trying to
arm with your door/window open.
i
It is possible to arm the system
with “open” door contact (i.e.
windows open).
Jamming and interference
detection disabled as default.
If jamming and interference is of concern,
please enable via “Controller” -> “Panel
Setting”
i
Supervision is disabled as default
(recommended).
Enable or disable supervision detection on
the control box. PIR, Door Contact, Smoke
Detector and Siren can be monitored for
outage using this feature. Except for Smoke
Detector (which is always on), the other three
accessories need to have supervision enabled
on board to facilitate this feature.
Supervision can be enabled via “Controller” ->
“Panel Setting”.
i
Comfort LED is disabled as
default (recommended).
Please enable Comfort LED via “Devices” ->
Siren properties (arrow on the right).
NOTE: This function will significantly reduce
your Siren’s battery life.
i