5
1. Remove cotter pin.
2. Remove castle nut.
3. Remove washer.
4. Carefully pull up on spring hub to
disengage spring.
5. Remove spring and note orientation.
6. Remove lever handle.
7. Pick-up flat gear, flip and orient stop on
opposite side of stop post. See pictures
for orientation.
8. Install spring upside down from original
orientation and place spring leg on
opposite side of stop post from original
installation orientation. See pictures for
orientation.
9. Install lever 180 degrees from original
position.
10. Install spring hub with stamped number
in the 6 o'clock position.
11. Rotate spring leg around with needle
nose pliers to engage notch in spring
hub, refer to pictures for reference
position. Press down on spring hub to
ensure complete engagement.
12. Install washer.
13. Install castle nut, do not over tighten,
verify by insuring lever returns
horizontally on its own.
14. Install cotter pin.
Tools Needed: Needle Nose pliers, Crescent wrench.
To Change Hands:
Notch for spring to engage for left hand reverse operation
Spring orientation for right hand reverse operation
LEFT HAND REVERSE
Castle Nut
Spring Hub
Flat Gear
Stop Post
Cotter Pin
RIGHT HAND REVERSE
Castle Nut
Spring Hub
Flat Gear
Stop Post
Cotter Pin
An ASSA ABLOY Group brand
80-8470-0626-000 (01-13)