Function Screw Position
R
1. Check cylinder components.
NOTE:
Cylinders longer than 1-1/4" (32) will require collars.
Refer to Yale cylinder
collar chart, below.
2. When required, cut cylinder tailpiece.
3. Assemble cylinder.
Insert cylinder housing prongs into matching notches of
escutcheon.
Pass cylinder tailpiece thru cylinder collar (when required)
and slot in cylinder housing cam.
Fasten cylinder using (2) mounting screws.
DO NOT OVER TIGHTEN SCREWS.
4. Check cylinder action.
Rotate cylinder tailpiece to cam the clutch lever down.
This depresses the trim spindle assembly which disengages
the trim spindle from the lever handle, putting the trim
in a free-wheeling, locked mode.
Trim Assembly Instructions
CAM TIP DOWN
Position
Classroom
Function
Position
Storeroom
Function
5. To Change Trim Function:
Rotate cam tip to down position (locked mode).
Move function screw as shown.
4
Yale
R
Cylinder Collar Chart
Cylinder Length
Collar
None
1-1/8" (29)
1-1/4" (32)
1-1/2" (38)
None
1765.250**
How to Change Handing
626F, 627F, 628F, 690F and 691F Series Exit Device Trim
Right Hand Reverse Gear & Spring Orientation
Left Hand Reverse Gear & Spring Orientation
Notes:
1. During change ensure black driven gear does not rotate.
2. Please wear safety glasses and be aware of spring tension on spring hub upon removal and assembly.
3. Light lubrication is recommended under flat gear, white lithium grease can be used.
An ASSA ABLOY Group brand
80-8470-0626-000 (01-13)