1030482G - 3/6
RUBBER CORD
CINCHERS
THE RUBBER CORD SHOULD BE VERY TIGHT
ACROSS THE SURFBOARD(S).
ADJUSTING THE RUBBER CORD WITH BOARD(S)
Unhook loop from the Strap Cap,
and put your board on the crossbars.
• Slide the center anchor (if necessary)
within a few inches of the board.
• Tighten the Turn Key firmly.
• Replace loop over Strap Cap.
Cord must be pulled very tightly into
slot and cinchers.
SLOT
LIMITED WARRANTY: Yakima Products (“Yakima”) will repair or replace merchandise which proves defective in materials and/or workmanship. The limited
warranty is effective for three years from the date of purchase. The limited warranty is applicable only if the Fit List and instructions are followed and the
products are used properly. If a customer believes that a Yakima product is defective, the customer must return it to an authorized Yakima dealer with proof of
purchase. Yakima will then issue authorization to the dealer for the return of these products. If an article is found to be defective upon inspection by Yakima,
Yakima will repair or replace the defective article at its discretion without charge. The customer will pay freight to Yakima, and Yakima will pay any applicable
return freight. Unauthorized returns will not be accepted. Normal wear and tear of Yakima products or damage resulting from misuse, accidents, or alterations
are not covered by this Limited Warranty.The purchaser acknowledges that Yakima has no control over the attachment of its products to vehicles or the
attachment of items to the Yakima products. Accordingly, Yakima cannot assume responsibility for any damage to any property arising out of the improper
attachment or use of its products. In addition, this Limited Warranty applies only to Yakima products and not to other products used in conjunction with Yakima
products. This Limited Warranty is in lieu of all other warranties, expressed or implied, and does not cover consequential damages of any kind that may arise
from the use or misuse of any Yakima product.
BEFORE DRIVING AWAY:
• Make sure the load is tight!
• Check to make sure the cord is pulled very
tightly into slot and cinchers.
• After driving 15 minutes of travel, check to
make sure the load is still tight!
WARNING: ATTACHMENT HARDWARE CAN
LOOSEN OVER TIME. CHECK BEFORE EACH
USE, AND TIGHTEN IF NECESSARY. FAILURE
TO PERFORM SAFETY CHECKS CAN RESULT
IN PROPERTY DAMAGE, PERSONAL
INJURY, OR DEATH.
(TOP VIEW)
CARRY BOARDS WITH THE FINS FORWARD
AND WITHIN 6" OF THE FRONT CROSSBAR.
FINS MUST BE INSTALLED.
Check condition of the Rubber Cord and
replace if worn.
IF IT NEEDS ADJUSTING:
• Pull the end loop off of the Strap Cap.
• Pull both cords out of the cinchers.
• With the rubber cord free, move it in the desired
direction. When the tension is adjusted
correctly, pull cord tightly into the slot, and
push each cord back into the cincher.
• Be sure the Rubber Cord is secure in the
Cincher and tight across the surfboard(s) when
the loop is pulled over the Strap Cap.
FAILURE TO SECURE CORD PROPERLY COULD
CAUSE LOSS OF BOARD(S), PROPERTY
DAMAGE, PERSONAL INJURY OR DEATH.
HOLE
