1033604D-7/27
Center the bar so
that the ends of the
crossbar protruding
from the towers are set
to an equal distance.
Center round bar.
Locate the silver
bar tightener
.
Complete assembly of tower/bar system.
Assemble bar to tower by
tightening silver bar screw using
integrated assembly device.
CHECK THE INSTALLATION!
Grip the crossbar inboard to towers;
push and pull using only arm strength.
The vehicle should rock back and forth,
but the RailGrabs should not budge.
Check your work.
Be sure to tighten
both
towers!
Overview
Claw Set Up
Install first
set of towers
Determine
crossbar spread
Install second set
of towers
YOU
ARE
HERE
Note the vertical position
of the claw, and repeat the
process for the other tower.
Check both towers and
readjust as necessary.
TIP: Look at the markings
on the claw base relative
to the markings on
the claw, and use this
measurement to help in
adjusting the other tower.
