IF YOU HAVE BARS THAT CAN BE MOVED…
Move the bars to minimum 30” (76cm) apart.
• Insert screws with
washers into each joint
and tighten them.
ATTACH FAIRING TO EITHER END OF BASKET.
Pry open the
SnapArounds,
attach them to the
LOWER FRONT BAR.
• Insert bolts through washers, fairing
and SnapArounds.
• Attach knobs and TIGHTEN.
NOTE: The fairing can
fold down when carrying
accessories and long loads.
ASSEMBLE THE BASKET.
• Remove the machine screws from
the ends of the LoadWarrior tubes.
LOAD BASKET ONTO RACKS.
Center basket over your rack’s crossbars.
DO NOT ATTACH BRACKETS
TO UNSTABLE POINTS.
Do not attach brackets at these locations.
•IF YOU HAVE FIXED BARS:
•IF YOUR BARS MOVE:
(SIDE VIEW)
A friend
would make
this easier .
Q TOWER OWNERS:
NEVER REPOSITION THE Q TOWERS!
IF YOU HAVE “Q TOWERS”
OR BARS THAT CANNOT MOVE…
Continue to STEP
.
Position the support brackets above your
vehicle’s crossbars.
It may be necessary to move the
bracket to a new position, or to
adjust the basket position.
KEEP BAR
BELOW TAB!
POSITION THE COVER BRACKETS.
Position cover bracket onto installed
support brackets.
Hooked tab should cover the larger
support bar.
Arrow points inboard to
center of vehicle.
TIGHTEN YOUR CROSSBARS
IF YOU LOOSENED THEM.
• Place the brackets
OUTSIDE of the
basket frame.
• Tabs on brackets face
INBOARD.
