6100015154_9812176 _Rev3
5/6
INSTALL PLATFORM PIVOT MOUNTS
From the LockNLoad Platform
kit (sold separately), position
Pivot Mounts into each Pivot
Bracket Assembly, lining up the
rivnut holes on the Mounts with
the holes on the brackets.
Where possible, always use the centre holes for
attaching to Pivot Bracket. If extra clearance
is needed due to Platform-to-roof fitment
needs, the offset holes can be used.
!
SECURE PLATFORM PIVOT MOUNTS
Secure all Platform Pivot Mounts with 2x 16 mm M6 Capscrews with Washer from
LockNLoad Platform kit as shown.
Tighten all Capscrews to 4 Nm with the provided 4 mm
Ball End Allen Key or a suitable Torque Wrench.
NOTE -
The Pivot Mount
assembly will still have
movement after securing
which is intended.
NOW SWITCH TO YOUR LOCKNLOAD PLATFORM
INSTRUCTIONS AND CONTINUE FROM THE
‘VEHICLE MOUNTING INSTRUCTIONS’ PAGE.
!
12
11
10
REPEAT STEPS TO OPPOSITE SIDE
Repeat steps 1-9 for securing opposite side of RuggedLine Spine.
Ensure both Spines are securely positioned on vehicle roof. Check each screw is
secure before proceeding to install LockNLoad Platform to RuggedLine Spines.
