6100001659-Rev1
4/9
BAR SLOT COVERS (OUTSIDE LEG)
Measure the Bar channel outside
of the Legs and subtract 20mm from
this measurement.
Using the remaining pieces of Slot
Cover from Step 12, cut to this
length and insert into the underside
channel of each Bar end as shown.
13
-20mm
10
CHECK BAR SLOT MEASUREMENTS
Using a Tape Measure, record Leg to underside slot distance of
each Bar in the table (right). Ensure measurement is taken from
the centre of the Legs as shown. The ends of each bar should
be the same measurement respectively, if not, repeat Step 9.
BAR SLOT MEASUREMENTS
Front Bar (X)
Rear Bar (Y)
______mm x2
______mm x2
X
Y
X = X
Y = Y
X
Y
BAR SLOT COVERS
Cut Bar Slot Covers as per measurements recorded
in the table on Step 10 and push into underside
channel of front and rear Bar ends as shown.
NOTE
- Bar Slot Covers to be
inserted with fl at side visible.
12
SECURE LEGS TO BARS
Tighten all M8 Hex Bolts
to 7Nm using a 13mm
Socket Wrench.
11
