6100001659-Rev1
3/9
INSERT LEGS
Slide Leg assemblies into the underside
channel of LOCKN’LOAD Bars (sold
separately). If Leg assemblies will not
slide in, loosen Screws to increase gap.
7
BAR LOCATION
IMPORTANT: Before beginning Bar installation, identify where along the gutter you want
the front and rear Bars fi tted. We recommend a minimum of 700mm between Bars.
8
≥ 700mm
BAR PLACEMENT
Carefully place a Bar assembly over vehicle.
Take care not to damage vehicle.
Slide Legs
along Bar until
both legs are positioned inside the vehicle gutter. Use a Tape Measure to ensure
even Bar overhang on each side, re-adjust if required. Finger tighten one Screw on each Leg to
secure Leg position along Bar.
Repeat process for remaining Bar assembly then carefully remove Bars from vehicle.
=
=
9
