Instruction #1036055A-4/9
4X
1.5 Nm (13.3 in lb)
Center cross bars and attach
SkyLine or Control Towers to
crossbars according to your
SkyLine or Control Tower
instructions.
10
11
12
13
14
4X
Install covers
when rack is not
attached.
USING THE COVERS WILL
HELP KEEP THE BASES
FREE OF DEBRIS.
•
BE SURE ALL HARDWARE IS
SECURED ACCORDING TO
INSTRUCTIONS. FAILURE TO
PERFORM SAFETY CHECKS BEFORE
DRIVING AWAY CAN RESULT IN
PROPERTY DAMAGE, PERSONAL
INJURY, OR DEATH.
READ THESE WARNINGS!
MAKE SURE SKYLINE
OR CONTROL TOWERS,
WITH BARS INSTALLED,
SEAT COMPLETELY WITH
LANDING PAD. IF THEY
DO NOT SEAT PROPERLY,
REPEAT STEPS 9-12.
For additional product
support , visit yakima.com/
support or contact us directly
at (888)925-4621 Monday
through Friday, 7:00 AM to
4:00 PM, PST.
DO NOT EXCEED MAXIMUM
WEIGHT LIMIT FOR YOUR
VEHICLE.
Continue with
SkyLine
or
Control Tower
installation.
•
ATTACHMENT HARDWARE CAN
LOOSEN OVER TIME. CHECK AND
TIGHTEN IF NECESSARY, BEFORE
EACH USE.
•
TO AVOID DAMAGE YOUR VEHICLE’S
FINISH REMOVE AND CLEAN
LANDING PADS AND MOUNTING
POINTS PERIODICALLY AS ROAD
SEDIMENT WILL ACCUMULATE
OVER TIME.
While holding the SkyLine or Control Tower above the
Landing Pad, fully tighten Landing Pad to 1.5 Nm (13.3
in lb) (use the long end of the wrench as shown).
Re-insert SkyLine or Control
Tower into the Landing Pad, fully
tighten tower (refer to tower
instruction) and close cover.
Open one SkyLine or Control Tower
cover, and lift it up while the opposite
tower is still engaged.
DO NOT OVER TIGHTEN AS DAMAGE TO
THE ROOF MAY OCCUR.
Repeat the process again for the
other Landing Pads to ensure
they have not changed position.
To review your vehicle’s
specific weight limit
and load limitations
for accessories, visit.
yakimatech.com.