1033312A-2/12
The holes in the bases
must align to each other.
SECURE WITH
“PLUS 2” BOLT.
INSERT bolt and washer
from RIGHT TO LEFT.
TIGHTEN with
7/8" wrench.
SECURE bolt
with safety
clip.
Tighten with hex
wrench (included)
and 17 mm wrench.
Insert bolt, washer,
and nut, in order
shown.
ROTATE PIVOT ARM CLEAR OF SUPPORT TRAY.
• Rotate pivot arm
to other side of
support tray.
• Extend hook to
end of arm.
• Attach second tray in opposite direction.
• Install tray with the pivot arm facing towards you.
• Secure with hardware.
ATTACH SECOND TRAY TO BASE.
SECURE WITH HARDWARE.
To release hook,
press the red trigger
on the handle.
REMOVE BASE CAP FROM
HOOKUP CARRIER.
INSERT BASE INTO
INSTALLED HOOKUP.
Pry the cap from
the base of the
HookUp carrier
with a flat tool.
Keep the cap in a safe
place for future use.
ATTACH FIRST TRAY TO BASE.
Align holes in tray to holes in base.
FIRST TRAY:
Wheel strap is to your
right, and pivot arm
faces you.
wheel strap
pivot arm
Slide the hook down enough to
clear the rear wheel cradle.
