1032499A-2/12
Install the extension.
REMOVE the end
cap by prying it
from the crossbar.
Press the sand dollar
disc toward the bar
until the bar clamp
completely covers the
end of the bar.
Tighten the clamp
screw using the
wrench.
There must be at least 1.5”
of crossbar to install
the extension.
Loosen and slide
your crossbar if necessary.
Do not forget to
tighten the towers again!
Extend the bar away from the car.
TIGHTEN THE KNOB.
• NEVER extend the bar with a
quick, throwing action.
• If the clamp becomes
disengaged from the end of the
crossbar, tighten the clamp
screw as in step 4 through 7.
Inside of crossbar should be free of
heavy corrosion. This could prevent
the extension from operating smoothly.
Loosen the
knob so the
the bar can
slide.
DECIDE WHICH BAR
WILL HOUSE THE
EXTENSION.
We recommend
using the front
crossbar.
Carefully insert the
extension into the open
crossbar.
Loosen the bar clamp
screw using the wrench
provided (on the carton lid).
MEASURE:
Q TOWER USERS:
Do not loosen your towers!
If your crossbars are too short, you
could install longer crossbars, or slide
your existing bars off center. In any
case, you must completely reinstall your
system using the instructions, and the
measurements specific to your vehicle.
If you have lost your instructions, see your
Yakima dealer.
