Load your bike’s forks.
Attach hex key
but do not
tighten.
Release a strap end
by pressing the red
button.
SQUARE BARS:
You may need to reposition
the bolt as in Step 9 to angle
the tray.
Tighten the hex key.
ROUND BARS:
Rotate wheel tray to
accommodate bike wheel.
Tighten the hex key.
Rest the rear wheel
into the tray.
Insert strap end
behind red
button.
Pull the strap
tightly against
the wheel rim.
TEST THE STABILITY
OF THE
INSTALLATION BY
TUGGING ON
FORK LEG.
If tray can move on the bar,
tighten the hex key.
If forks move out of the
skewer —
Open lever and tighten
the nut slightly. You
may need to loosen or
tighten the nut so that
lever closes firmly
with resistance.
If the wheel is loose in the tray —
Pull down on the strap ends.
(Some bike wheels may be too
narrow to allow a tight fit. The
bike is still secure.)
Tray can rotate on the bar to
adjust to wheel. After adjusting,
tighten the hex key.
If pod
can rotate —
Remove the
skewer and pod
cover, and tighten
the screws.
Always replace
the pod cover.
Ride Safe!
SECURE THE
REAR WHEEL.
With lever open, tighten
the nut until the lever
closes with FIRM
resistance.
Your bike’s forks are secure
ONLY after the lever
closes with solid
resistance.
TEST YOUR INSTALLATION! If forks can move in the mount,
open the lever and tighten the nut again.
Set the bicycle
forks vertically
onto the skewer.
Prevent damage to
your forks!