TO Flame Sensing Evaluation Kit (Analog) USEQFCK4000000
The above information is believed to be correct but does not purport to be all inclusive and must be used only as a guide.
© KEMET
Electronics Corporation • KEMET Tower • One East Broward Boulevard
Fort Lauderdale, FL 33301 USA • 954-766-2800 • www.kemet.com
7
Figure 6
– Software Main Page
If the data capture board is connected to the required com port, the status bar at the bottom
of the main display will show the message “Connected on COMXX” on the right side, and the
left will show the Flame Detection Demonstrator Kit firmware version. Sensor signal will be
visible on the signal viewers on the right.
If the program fails to make a connection to the data capture board, an error message is
displayed and the screen returns to its initial screen. Check the USB and power connection
and try to connect again.
4.3
Flame Detector Settings
This flame detector
’s specific settings allow for selection of the number of channels, and
optical filters and gain on each channel. The settings can be accessed by selecting the
Show
Settings
item in the
Options
menu, as shown in Figure 7. The settings can only be changed
when the software is successfully connected to the Demo Kit.
Figure 7
– Finding the Demo Kit Settings
