XCUT
-150
POWER
ON
OFF
XCUT
-150
POWER
ON
OFF
Tape Setting
6
■
Put AC cord into Power Inlet accordingly.
■
Make sure the Power Switch is off then plug into an appropriate grounded
AC outlet.
■
Turn on Power Switch.
・
When switching on, you will see the setting length as registered before.
・
Manual mode is set when switching on.
■
Put your tape into Bobbin.
・
Grip Clutch Bobbin tightly and put your tape into Clutch Bobbin. And set it
so as to the tape comes to the middle of Clutch Bobbin.
■
Put Clutch Bobbin with your tape into machine.
■
Release Safety Cover Hook and open Safety Cover.
■
After folding the tape edge 20mm, please put it between Roller #1 and
Silicon Sponge Roller.
■
Feed the tape while pressing FWD button.
・
Make sure that the tape comes out.
・
Feed the tape while pressing FWD button until it comes out straight.
・
FWD function is operated only when pressing FWD button.
■
Close Safety Cover and place Safety Cover Hook to the original position.
■
Press Start button.
・
When pressing FWD button first and Start button, tape cutting will be
enforced.
・
Remove the cutting tape.
■
Please follow the instruction when removing a tape from between Rollers.
・
Release Safety Cover Hook and open Safty Cover.
・
Press REV button and tape will be reversed.
・
When tape is removed, release your finger from REV button.
Caution: Please notice that tape may be caught at the rear of the roller when
pressing REV button even though tape is already removed.
OUTLET
AC CORD
INLET
Connect to Power Cord
Put the tape into Bobbin
Open Safety Cover
Cutting tape
Remove tape
Set a tape into between rollers
Confirm the status of setting