Yaesu VX-8R, Руководство по эксплуатации

Страница: 21 / 172

VX-8R O
PERATING
M
ANUAL
19
T
RANSMISSION
Once you have set up an appropriate frequency inside one of the three (or four) Amateur
bands on which the
VX-8R can transmit (50 MHz, 144 MHz, or 430 MHz, plus 222 MHz
on the USA version), you’re ready to transmit. These are the most basic steps; more ad-
vanced aspects of transmitter operation will be discussed later.
1. To transmit, press the PTT switch, and speak into the
front panel microphone (located in the lower right-hand
corner of the speaker grille) in a normal voice level.
The LED of the
or which is designated the
“Main” band will glow red during transmission.
2. To return to the receive mode, release the
PTT
switch.
3. During transmission, the relative power level will be
indicated on the LCD. Additionally, the “ L1 ”, “ L2 ”, “ L3 ”,
or “ HI ” icon will appear at the left side of the PO meter,
corresponding with the “Power” Level setting.
1) If you’re just talking to friends in the immediate
area, you’ll get much longer battery life by switching to Low Power opera-
tion. To do this, press the
key, then press the key so that the “Low
Power” icon appears at the bottom of the display. And don’t forget: always have an
antenna connected when you transmit.
2) Transmission is not possible on “Sub” band and any operating bands other than the
50 MHz, 144 MHz, 222 MHz (USA version), and 430 MHz bands on the “Main” band.
C
HANGING THE
T
RANSMITTER
P
OWER
L
EVEL
You can select between a total of four transmitter power levels on your VX-8R . The exact
power output will vary somewhat, depending on the voltage supplied to the transceiver.
With the standard
FNB-101LI Battery Pack and external DC source, the power output
levels available are: “
L1
”, “
L2
”, “
L3
”, or “
HI
”
To change the power level:
1. The default setting for the power output is “High;” in
this configuration, the display shows the “ HI ” icon.
Pressing the key, followed by the key, causes
the power level “ L1 ”, “ L2 ”, or “ L3 ” to appear.
2. Press the key, followed by the key (repeat-
edly, if necessary) to make the “
HI
” icon appear and
restore “High Power” operation.
O
PERATION