Yaesu VX-8R, Руководство по эксплуатации

Страница: 10 / 172

VX-8R O
PERATING
M
ANUAL
8
Figure 1
Figure 2
A
NTENNA
I
NSTALLATION
The supplied antenna provides good results over the entire frequency range of the trans-
ceiver. However, for enhanced base station medium-wave and shortwave reception, you
may wish to connect an external (outside) antenna. The supplied antenna consists of two
sections: the “Base Antenna” (used for operation above 50 MHz), and the “Extender Ele-
ment” (used for monitoring of frequencies below 50 MHz).
T
O
I
NSTALL THE
S
UPPLIED
A
NTENNA
Hold the bottom end of the antenna, then screw it onto the
mating connector on the transceiver until it is snug. Do not
over-tighten by use of extreme force.
When operating the VX-8R on the 50 MHz band and lower
frequencies, disconnect the antenna cap from the base antenna,
then screw the Extender Element onto the Antenna Base. Of
course, the
VX-8R
may be operated on frequencies higher
than the 50 MHz band while the Extender Element is still at-
tached to the Antenna Base.
Notes:
€ Never transmit without having an antenna connected.
€ Carefully turn the supplied antenna onto the SMA jack.
Never twist the upper part of the antenna while screwing
it onto the mating connector of the transceiver.
€ If using an external antenna for transmission, ensure that
the SWR presented to the transceiver is 1.5:1 or lower.
€ Take care, do not lose the antenna cap when removing it
from the Base Antenna.
B
ELT
C
LIP
I
NSTALLATION
ˆ Install the supplied Belt Clip to the FNB-101LI
Battery Pack using the supplied two screws
(
Figure 1
). Use only the screws included with
the Belt Clip to mount the Belt Clip to the back
of the Battery Pack!
ˆ If you do not need the Belt Clip, install the sup-
plied Plastic Cap to the Battery Pack (
Figure
2 ). If you install the belt clip later, push the Plas-
tic Cap out with a small tool or screwdriver.
I
NSTALLATION OF
A
CCESSORIES