6
SDX Series Azimuth Rotator
r
Prepare the optional
C-1000
Connection Cable.
r
Remove the Top cover from the controller.
r
Connect the 8-pin connector of the
C-1000
Connection
cable to the exposed 8-pin connector located the rear
left corner in the controller.
r
Route the 5-pin connector of the
C-1000
Connection
cable through out the rubber grommet on the rear panel
of the controller, and connect it to the
AZ
connector on
the rear panel of the
GS-232A
(Figure 4).
r
Replace the Top Cover.
P
OWER
& C
ONTROL
C
ONNECTIONS
r
Connect the supplied DC cable to a source of 12 VDC.
The red lead connects to the Positive (+) DC terminal,
and the black lead connects to the Negative
(–) DC terminal. The
GS-232A
requires 110 mA. The
supplied cable has a 500-mA fast-blow fuse. Use only
the same type fuse for replacement.
r
Plug the coaxial power connector into the
DC 12V
jack
on the
GS-232A
rear panel.
I
NST
ALLA
TION
To DC 12V Power Source
To Serial port of the computer
SDX series
Azimuth Rotator
Figure 4
Output Grommet for
C-1000 Connection Cable
Exposed 8-pin Connector
(Inside of the Controller)
Optional C-1000 Connection Cable
