Yaesu FTV-1000, Руководство по эксплуатации

Страница: 6 / 16

FTV-1000 Operating Manual Page 4
TRANSCEIVER Jack
This jack should be connected to the ANT jack of
the MARK-V FT-1000MP, providing converted receive
signals to the transceiver. When the FTV-1000 is turned
off, the ANT NOR jack (which may be connected to
your HF antenna system) will be connected, through
the
TRANSCEIVER jack, to the MARK-V FT-1000MP.
ANT ALT Jack
Connect your 50 MHz antenna’s 50
Ω
coaxial cable
to this M -type (“SO-239”) connector.
ANT NOR Jack
Connect your antenna’s 50
Ω
coaxial cable (either
HF or 50 MHz) to this M -type (“SO-239”) connector.
DC POWER IN Jack
This is the power input jack of the FTV-1000 . Con-
nect the DC power cable from the FP-29 AC power
supply to this jack.
DC POWER OUT Jack
This jack provides DC voltages to the MARK-V FT-
1000MP. When the FTV-1000 is switched off, the DC
voltages from the FP-29 AC power supply will auto-
matically be fed to the MARK-V FT-1000MP.
GND Terminal
Use this terminal to connect the FTV-1000 to a good
earth ground, for safety and optimum performance. Use
a large diameter, short braided cable.
BAND DATA Jack
This 8-pin DIN jack connects to the BAND DATA
jack of the MARK-V FT-1000MP via a supplied con-
trol cable.
LIN BAND DATA Jack
This 8-pin DIN jack connects to the BAND DATA
jack of the VL-1000 solid-state Linear Amplifier, pro-
viding control signals for the VL-1000.
ALC SET Potentiometer
Insert a small insulated screwdriver here, and turn
the trimmer inside to adjust the maximum output power
of the
FTV-1000 .
LIN ALC Jack
This RCA jack provides for input of ALC voltage
from the VL-1000 Linear Amplifier, for control of the
MARK-V FT-1000MP’s drive level.
ALC Jack
This RCA jack provides ALC (output) voltage, for
control of the MARK-V FT-1000MP’s drive level. The
ALC control voltage range is 0 to –4 VDC.
TX IN Jack
This RCA jack is for connection to the TRV jack of
the MARK-V FT-1000MP. The optimum drive level is
approximately 50 mVrms at 50
Ω
.
Rear Panel Controls & Connectors