16
Advanced Operation
Setting DTMF Autodialer TX delay time
A longer delay may be set between the time the transmitter is keyed and the first DTMF
digit is sent:
1. Press and hold the [
MHz
(
SETUP
)] key to enter the
Set mode.
2. Rotate the
DIAL
knob to select “
DT DELAY 17
”.
3. Press the [
MHz
(
SETUP
)] key momentarily, and
then rotate the
DIAL
knob to select the desired
delay time (50 MS / 250 MS / 450 MS / 750 MS /
1000 MS).
Default:
450 MS
4. Press and hold the [
MHz
(
SETUP
)] key to save the
new setting and exit to normal operation.
Checking the Repeater Uplink (Input) Frequency
It is often helpful to be able to check the uplink (input) frequency of a repeater, to see if
the calling station is within direct (“Simplex”) range.
Note:
This function can only be used through the programmable keys [P1] to [P4] on the
microphone.
Refer to the “Programming the Key Assignments“ on page page 3.
To do this (Example: When “REV” is assigned to [
P4
]):
1. Press the Microphone [
P4
] key.
You’ll notice that the display has shifted to the re-
peater uplink frequency.
While listening on the repeater input frequency us-
ing the [
P4
] key, the repeater offset icon will blink.
2. Press the [
P4
] key again to cause operation to revert to normal monitoring of the re-
peater downlink (output) frequency.
