![background image](http://html.mh-extra.com/html/yaesu/ftdx101d/ftdx101d_operation-manual_892942078.webp)
73
•
Check Memory Channel Status
Before programming a memory channel, the
current contents of that channel may be verified
without the danger of over-writing the channel.
1. Press the [V
u
M] key.
The memory channel list will be displayed.
2. From the channel list, touch and select the
memory channel and check, or change the
operation mode.
Alternately, the memory channel may be se-
lected by rotating the [MULTI] knob.
● Press the [MULTI] knob to enter memory
mode on the selected channel.
3. To change the operation mode, touch [MODE],
rotate the [MULTI] knob to select the mode
then press the [MULTI] knob.
4. [WRITE] will turn orange, so touch [WRITE].
5. The channel list changes, and the selected
memory channel on the list is framed in or-
ange.
6. Press the [V
u
M] key to return to the previous
screen.
V/M
This key toggles frequency control between VFO
and the memory system.
The contents of the memory channels can be
recalled and used later.
• Recall a Memory Channel other than
the last used VFO frequency
1. Press and hold the [V/M] key.
The memory channel list will be displayed.
2. From the channel list, touch and select the
desired memory channel.
Alternately, the memory channel may be se-
lected by rotating the [MULTI] knob.
3. Press the [MULTI] knob
Memory channels can also be called up in
the following method.
1. Press the [V/M] key.
2. Press the [FUNC] key.
3. Touch [MEM CH].
Rotate the [MULTI] knob to select
the desired memory channel.
● While using the recalled memory, the stored
frequency and operating mode can be
changed temporarily (see “Memory Tune
Operation” below).
4. To exit from memory mode and return to the
VFO mode, press the [V/M] key.
If a memory group is set, the channels
stored in the selected memory group may
be recalled.
•
Memory Tune Operation
You may freely tune off from any memory channel
in a “Memory Tune” mode, this is similar to VFO
operation. So long as you do not over-write the
contents of the current memory, Memory Tune
operation will not alter the contents of the memo-
ry channel.
● The “
MT
” notation will appear instead of the
“M-nn”.
Press the [V/M] key to return to the originally
memorized frequency of the current memory
channel.