Yaesu FT-817ND, Руководство по эксплуатации

Страница: 47 / 84

45 FT-817
ND
Operating Manual
M
EMORY
O
PERATION ON
“R
EGULAR
•EM
EMORY
C
HANNELS
Normal Memory Storage
1. Tune in the desired frequency, and set the operating mode and bandwidth. If this is an
FM channel, set up any required CTCSS/DCS and repeater shift configurations. Stan-
dard (default) repeater shifts do not require you to utilize the “split” frequency memory
technique, described later.
2. Press the key momentarily, then rotate the knob, as needed, until Operating
Function Row 2 [ MW , MC , TAG
] appears on the display.
3. Press the
(
MW
) key momentarily to enter the “Memory Check” mode, which is
used to find an unused memory channel. The frequency stored (if any) on the current
memory channel will be shown in the display.
4. Rotate the knob to select the channel number on which you wish to store the
current frequency data.
5. Press and hold in the
(
MW
) key for one second until you hear a double beep; the
second beep confirms that the frequency information was successfully stored.
Split-Frequency Memory Storage
You can also store “Split” frequencies, such as when operating on a repeater system not
utilizing a “standard” offset. This procedure may also be used for DX work on 7 MHz SSB, etc.
1. In the VFO mode, set the desired Receive frequency and mode.
2. Press the key momentarily, then rotate the knob, as needed, until Operating
Function Row 2 [ MW , MC , TAG
] appears on the display.
3. Press the
(
MW
) key momentarily to enter the “Memory Check” mode, which is
used to find an unused memory channel. The frequency stored (if any) on the current
memory channel will be shown in the display.
4. Rotate the knob to select the channel on which you wish to store the receive
frequency data.
5. Press and hold in the
(
MW
) key for one second until you hear a double beep, which
confirms that the Receive frequency data is now stored.
6. Now, set the desired Transmit frequency and mode on the VFO.
7. Press the
(
MW
) key momentarily;
do not
rotate the knob!
8. While the “memory channel number” is blinking, press and hold in the
PTT
switch;
while holding it in, press and hold in the
(
MW
) key for one second. The double
“beep” will confirm that independent Transmit frequency data is now stored. You may
now release the PTT switch.
In step 8 above, pressing the PTT switch does not activate the transmitter. It sim-
ply sends a signal to the microprocessor that an independent Transmit frequency
is being stored on the same channel as a previously-stored Receive frequency.
M
EMORY
O
PERATION