Dress the DWN button again to play back this recording. You will notice t sounds
a little 'scratchy'. Bit rates 3 and 4 provide even longer recording times, but sound
even more scratchy (go ahead and try them). If you find you have a lot of left-over
time (as indicated on the S-meter), press any microphone button to stop recording.
Pick the fastest bit rate :hat gives you just the necessary recording time.
You can record any other memory segments in the same way you did your
callsign. You may even record while transmitting (if the DVS-1 is activated), in
which case Microphone recording is automatically selected. On-The-Air
Recording & Playback
When the DVS-1 is on, you can play back over the air anything that you have
previously recorded: select the Code to play back and then press :he DWN button
while holding the PTT switch.
You can also record incoming signals heard in the loudspeaker:
(1)
Press VOICE (if displaying frequency) to activate the DVS-I.
(2)
Press TONE, if necessary, to select the Speaker recording mode.
(3)
Select the desired Segmentation Code using the tuning knob, and then select a
Bit Rate using the REV button and tuning knob.
(4)
Press the UP button on the microphone to start recording.
(5)
Press the DWN button to play back the recording (and hold the PTT if you
want to play it back over the air).
Remote Recording & Playback
If you have a second transceiver (any type, but with a DTMF keypad), you can
operate the DVS-1 remotely using 3-key DTMF commands. To do his, the DVS-
1 must first be activated and then set to the Remote control Mode, as follows:
- 32 -
