Yaesu FT-70DE, Инструкция по эксплуатации

Страница: 23 / 32

• User CTCSS
Select the idle line frequency to remove signals such as idle line signals used by private railways and
control signals of MCA radio system.
• Tx Power
This item selects the TX Power.
• Skip
Select the scanning condition for receiving channels.
OFF: Performs scanning according to the set mode basic setting –SCAN RESUME.
SKIP: Skips the designated memory channels during scanning.
SELECT: Starts scanning from a designated channel and scans only designated channels.
• AUTO STEP
By ticking the checkbox of this item, the frequency step is set to “AUTO” automatically provides a suit-
able frequency step (frequency variation by rotating the DIAL knob) according to the frequency band.
By turning off the checkbox, the step setting become selectable.
• Step
Sets the channel step for receiving channels.
• TAG
Setting the memory tag, the checkbox of TAG is automatically ticked. When recalling this memory chan-
nel, the set memory tag is displayed. By Turning off the checkbox, the receive frequency is displayed in-
stead of the memory tag.
• Memory Mask
By ticking the checkbox of this item, the channel may not recall temporally.
Un-ticking the checkbox enables calling the memory channel.
• ATT
By ticking the checkbox of this item, the receive sensitivity is lowered by about 10dB. This is useful when,
for example, an adjacent strong radio wave interferes with the reception.
• S Meter SQL
Configure the normal noise squelch setting, and also the S-meter squelch level setting.
• BELL
Outputs a ringing tone when receiving a signal that satisfies the conditions set from the squelch type.
Set the number of times the tone (bell) rings.
• Half DEV
Lowers the transmit deviation to approximately half.
22 ADMS-10 Instruction Manual