Yaesu FT-4VE, Руководство по эксплуатации

Страница: 23 / 40

21
Memory Channel Scanning
The receiver may be set to scan memory channels:
1. While operating in the VFO mode, press the [
MR ] key to enter the Mem-
ory mode.
2. Press and hold the [▲] key or [▼] key.
Scanning starts of the memory channels begins.
If the scanner halts on an incoming signal, the back light will turn ON and
the decimal point between the “MHz” and “kHz” digits of the frequency
display will blink.
3. Press the function key to cancel the scanning.
Setting the Receive Operation When Scanning Stops
Press and hold
the Function key
→
Press the  or  key
→
Press the Function key
(Confirms the setting) (Enters the Set mode) (Select Set Mode "34 SCN.RSM")
1. Press the [▲] key or [▼] key to select the operation that is to be per -
formed after the scan stops:
Display Description
BUSY
(Default setting)
In BUSY mode, the scanner will halt on a signal
it encounters. Scanning will resume two seconds
after the other station signal ceases transmitting.
In the case of constant-carrier signals like Weather
Station broadcasts, the scanner will likely remain
on this frequency indefinitely.
HOLD
In HOLD mode, the scanner will halt on a signal it
encounters. Scanning will only resume when it is
manually re-initiated.
TIME
In TIME mode, the scanner will halt on a signal it
encounters, scanning will resume after five sec-
onds even if a signal is still on the frequency.
2. Press the PTT switch to save the setting and exit to normal operation.
The above Set Mode [ 34 SCN.RSM ] operation is common for all scanning
operations.