Yaesu FT-2900E, Руководство по эксплуатации

Страница: 41 / 90

37 FT-2900E O
PERATING
M
ANUAL
M
EMORY
O
PERATION
M
EMORY
B
ANK
O
PERATION
The large number of memories available in the FT-2900E could be difficult to utilize with-
out some means of organizing them. Fortunately, the
FT-2900E
includes provision for
dividing the memories into as many as eight Memory Banks, so you can categorize the
memories in a manner convenient to you. You may enter and exit the “Memory Bank”
mode by a single press of the Microphone’s [
½
] key, as we shall see below.
Assigning Memories to a Memory Bank
1. Recall the memory channel to be assigned to a Memory
Bank.
2. Press and hold in the [ D/MR
(
MW
)] key for one second, then
rotate the DIAL knob to select the Memory Bank number (“
b1 b1
b1 b1 b1 ” ~ “
b8 b8
b8 b8 b8 ”) you want as the
Memory Bank for this channel. The Memory Bank numbers
are found by rotating the
DIAL knob counter-clockwise past
memory channel “0.”
3. Press the [
D/MR
(
MW
)] key momentarily to copy the memory channel data into the
Memory Bank.
1) You may assign one memory channel into several Memory Banks.
2) The PMS memory channels (L0/U0 through L9/U9) may not be assigned to a
Memory Bank.
Memory Bank Recall
1. Press the [ D/MR
(
MW
)] key, if needed, to enter the Memory mode.
2. Press the Microphone’s [
½
] key to activate the “Memory
Bank” mode. The Memory Bank number will appear on
the display.
3. Press the [ #
] key to increment the Memory Bank (“
b1 b1
b1 b1
b1
”
through “ b8 b8 b8 b8 b8 ”).
4. Rotate the DIAL knob to select the memories within the
selected Bank; you will observe that you can only select
memory channels in the current memory bank. The small
memory bank number will appear, to the right of the fre-
quency display, two seconds after you complete memory
channel selection while operating within a Memory Bank.
5. To change to another Memory Bank, press the [ #
] key to
step up to the next-highest bank.
6. To exit from Memory Bank operation, just press the
Microphone’s [ ½
] key. The Memory Channel number will
appear steadily on the right side of the display, indicating that
you are now in the “standard” Memory Recall mode, without
utilization of the Memory Banks. The memories stored in the various Banks will remain in
those banks, however; you do not need to store them again.