13
①
①
②
③
Set the bobbin (FD-200
Ⅲ
, FD-300)
Adjust Torque of Bobbin (FD-200
Ⅲ
, FD-300)
Peel the film and set it on
FEEDING ROLLER.
BOBBIN
PIN
ROLLED FILM
①
Grip BOBBIN to insert ROLLED FILM.
②
Insert the ROLL to BOBBIN.
・
Set the ROLL at the center of BOBBIN.
③
Insert PINS at BOBBIN SHAFT SOCKET.
Bobbin of FD-200
Ⅲ
and FD-300 have Dual Torque Limiter to make the film running stable.
Depends on the application, you need to adjust the torque setting again.
Adjust the torque of Bobbin if there is any problem with film feed or film jammed.
■
If the torque is weak, it will cause film slack, curved film loading, and film jammed.
・
Hold PIN and turn ADJUST DIAL to m
a
ke it strong, following to the instruction below.
■
If the torque is strong, it may cause shorter cutting piece than setting, or failure for film feeding.
・
If the torque is strong, turn ADJUST DIAL to make it weaker following to below figure.
■
When you adjust the torque, remember the original position of ADJUST DIAL.
Then find the suitable torque position by turning it 1/4 rotation each time.
・
Set both side of SCALE MARK at the same position.
・
Do not tighten ADJUST DIAL too mach until the scale mark cannot be seen.
■
When you set the new roll, film may overrun and will slack a little bit.
However, it is not necessary to adjust Torque Limiter as long as the machine is working normally.
ADJUST DIAL
TORQUE LIMITTER
Hold
SCALE MARK
Loose
Tight
