6
Preparation
Preparation
This section contains detailed instructions for installing the camera. These instructions
assume that the installer has a good knowledge of installation techniques and is capable of
adopting safe installation methods.
Initial Power On Test
To ensure the camera works well after installation, please power on it for an initial test with the
following steps:
Connect the camera with correct power supply;
Connect control cable, video cable;
Power on the camera;
The camera will run a calibration procedure on power up and show the following messages.
If the camera fails at initialization, the following message will show on screen.
CAM FAIL
ADDRESS
: 001
PROTOCOL
: PELCO-D
BAUD RATE : 4800
SOFTWARE V1.4.10
ADDRESS
：
001
PROTOCOL
：
PELCO-D
BAUD RATE
：
4800
SOFTWARE
：
V1.4.10