•
7
Figure 2:
On/Off and engage button
•
To make Maximo operating, press twice the engage (On-Off) button, within 5 seconds
between the first pressure and the second one.
•
If the operation was successful, the receiver's beep stops and the system is fully
operational. The two multi-colored LEDs will flash indicating the transmission on the two
bands. The color of the LEDs will change according to the signal strength.
Indicatively, the LEDs will appear green within 5 meters from the receiver.
They will appear white within 8/10 meters from the receiver.
They will appear purple beyond 10 meters.
They will appear red if the transmitter is out of the receiver
’s transmission range.
WARNING:
From this moment Maximo is operating. Pay the maximum attention, because the
involuntary pressure on any of the transmitter buttons, will cause the activation of the
related command output.
IMPORTANT:
To preserve battery life, the transmitter automatically turns off after approximately ten
minutes from the last pressure of any button.
Before turning off, all LEDs flash and the transmitter vibrates for approximately 15
seconds. Press any key to turn the transmitter on for other ten minutes.
2.3. Deactivation procedure
To deactivate Maximo, follow this procedure.
•
Turn off the transmitter by pressing and holding the On/Off button for at least three
seconds, until all the LEDs light up (see figure 2). Releasing the button, the transmitter
turn off. The confirmation of the deactivation is given by the LEDs turning off and the
activation of the receiver's acoustic warning, caused by the failure to communicate.
•
Deactivate the receiver by pressing the On/Off boat button.
ATTENTION:
In emergency it is possible to deactivate the Maximo receiver pressing the On/Off
button on the boat without turning the transmitter off.
On / Off and engage button
