Yach Watchman Yacht Sentinel, Руководство пользователя

Страница: 16 / 21

16
SMS command Description
ALARM1=
Command to set the parameter for the
alarm input 1…4. The command has
ALARM2=
three parameters:
ALARM3=
1: ON/OFF enable or disable the alarm
ALARM4=
2: NC/NO the connector sensor set to normally closed or normally open
3: Alarm text to indicate the alarm in the alarm SMS. All three parameters can
easily be set with one command.
Examples:
Alarm4=off
Alarm4=on,nc,alarmtext
Alarm4=on,alarmtext
It is possible to set just one two or all three parameters with one command.
Note: All blank characters will be deleted and all characters uppercased.
OUT1=
Command to set the output 1…2 ON/OFF enables or disables the output
OUT2=
ALARM1/ALARM2/ALARM3/ALARM4 enables the output when the alarm
occurs.
Default = OFF
Note: ON connects the output direct to ground and OFF makes it High
impedance.
Note: If the output is set to Alarm, the output is OFF until the alarm occurs.
NAME=
Command to set the name of the boat. This name will be sent in each SMS.
Default: MY BOAT [max. 12 characters]
MMSI=
Command to set MMSI Maritime Mobile Service Identity (max 12 characters)
NEWPWD=
Command to change the default password for SMS commands. NEWPWD=
must be followed by the 4 digit password you wish to set. Example
NEWPWD=1111
TRACKING =n,d
Command to activate SMS tracking n = number of tracking SMS [0..20]
d = time between each SMS[1..10] mins example to activate tracking mode:
TRACKING=10,2
Example to deactivate: TRACKING=0
Note1:
For BATT set to 12/24
An alarm SMS will be sent if the battery voltage is below a defined
threshold voltage for at least 30 seconds. Due to this delay, it is possible to start some heavy
loads connected to the battery without a false alarm. The threshold voltage is 11V for a 12V
battery and 22V for a 24V battery. The parameter SMS will show the parameter BOATBATT=..V
with actual battery voltage
For BATT set to OFF: A shore power alarm SMS will be sent if the supply voltage for the Yacht
Sentinel is under a defined threshold voltage for 30 seconds. The parameter SMS will show the
parameter SHOREPOWER=ON/OFF to indicate a connected/disconnected shore power.