YAAHKIEH JONCO Series, Руководство пользователя

Страница: 27 / 40

24
7.3.3 AIR FILTER
After approximately 100 hours of use, or every month (whichever is sooner),
the air filter should be removed and cleaned thoroughly. During this cleaning
process, the air filter should also be thoroughly inspected for damages and
deterioration. We recommend a water-based degreasing agent. Allow to dry
fully before replacing the air filter.
NOTE: Never attempt to run the machine without an air filter in place.
7.3.4 BLADES AND ANVIL
*CAUTION*
Blades are extremely sharp, take care please!
Torque scale: 60-70Nm for blade and 35-45Nm for anvil.
Blades and anvil need cleaning after every chipping job, to protect it from
corrosion.
Sharpen or replace the blades as soon as the chipping performance begins to
deteriorate, or if you notice signs of chips or cracks.
1. Stop the engine (Put the ON/OFF switch in the “OFF” position) and
disconnect the safety switch cable.
2. Remove the feeding chute.
3. Put a rod into the hole (Figure 12). Pull the starter cord some more until the
rotor is blocked. Now it is safe to unscrew blade bolts. Always use gloves
when handling the blades.