March 2016
P 10
da Vinci
HD23F1JS016
CALIBRATE
Calibration is enabled for this new extruder module. Please update printer firmware via XYZware before
using the new extruder.
1. Active print bed calibration by selecting “UTILITIES”>”CALIBRATE”>”YES” on the screen.
2. Press the detection head on the right side of the print head according to the instruction of screen message,
followed by pressing OK.
3. Wait for detecting.
4-2A.
If the detecting result is shown as “FAIL”,
press "OK" to go to next page, and press "OK"
again to exit.
Note:
1.The dirt on the detection pin and the top of Extruder module will influence detection result. Make sure
that the dirt is cleaned before calibration.
2.If the residues is on the top of the Extruder module, the detection result will be shown as follows.
Clean the dirt before recalibration.
4-2B.
And check the detecting result by going to
“INFO”> ”LEVELING INFO”. Contact customer
service for the issue and provide the details of leveling
information.
4-1A.
If "SUCCESS" is shown for the detection
result, and "AUTO LEVEL OFF" is shown on the
third row on the screen, it indicates good platform
levelness. Press "OK" to exit and print.
3. The printer may enable or disable auto-level based on the result of calibration. You may switch off
the function manually under "Settings".
4-1B.
If you see "AUTO LEVEL ON" under “SUCCESS”,
this indicates that the print bed is slightly unleveled.
The printer will adjust the configuration based on the
detecting result automatically while "AUTO LEVEL" is
enabled. The printing mode helps to improve printing
quality with slower printing speed. You may switch off
the function under "Settings".
A 0000 0000 0000
B 0000 0000 0000
C 0000 0000 0000
[OK] TO RETURN
CALIBRATE
FAIL
AUTO LEVEL ON
[OK] TO CONTINUE
PLEASE CONTACT
CUSTOMER SERVICE
[OK] TO RETURN
A 0317 0320 0313
B 0318 0323 0308
C 0312 0300 0440
[OK] TO RETURN
CALIBRATE
SUCCESS
AUTO LEVEL ON
[OK] TO RETURN
CALIBRATE
SUCCESS
AUTO LEVEL OFF
[OK] TO RETURN
PRESS DETECTOR
NEXT TO EXTRUDER
[OK] TO CONTINUE
CALIBRATE
