7
DO NOT WORK ON LIVE CIRCUITS
-
Before working on any mains powered equipment, make sure that it is turned off,
and the mains plug is removed from the power point.
DO NOT USE IF DAMAGED
-
If the power lead becomes damaged or the rework station becomes faulty,
discontinue use immediately. To comply with safety standards, the power lead must
only be replaced by authorized technicians as special purpose tools are required.
Caution: Soldering irons or SMD Tweezers operate at high temperatures and can
easily burn people or objects. Do not touch the tip and heater at any time and keep
it a safe distance from flammable materials while the unit is on or while it’s cooling.
Please allow a sufficient time for it to cool before changing tips or servicing the
unit!
TEMPERATURE SETTING:
(No password set)
1.
Increase temperature: By pressing “▲” key one time, the digital will be increase “1”
numeral. If pressing “▲” key over 2 seconds then the digital numerals will be
forwarded counting continuously till the temperature up to what you desire to set.
2.
Decrease temperature: By pressing“▼” key, the same procedure as above.
PARAMETER SETTING:
1.
Press “SET” key and hold for at least 4 seconds until display shown “— — —”
sign then release the “SET” key. The sign “— — —” starts to flash and reminding
the user to input the mode lock password “010” (fixed). If the user inputs the same
number as “010”, the unit will enter the modes selection procedure, otherwise, the
unit will be back from the current mode automatically.
2.
After the unit enters the Modes selection, the LED will display “F-0”and flash.
Press “▲”or “▼” key to select modes. If the user doesn’t press “▲” or “▼” key
within 15 seconds or press “SET” key one time, then the unit will be immediately
back from the Parameter Set status.
For example: F-0 → F-1 → F-2 → F-3
↑ ↓
← ← ← ←
3.
Password Setting:
When the LED displays “F-1” and flashes, press “SET” key one time and the unit
enters the Password Set status. At this moment, the LED displays the pre-set value.
Press “▲” or “▼” key to change password set value. If the user sets “000” that
means the unit will be under the status of no password. If the user sets “100” then
means the unit will be under the password status. Press “SET” key once to finish
password setting and the unit will backup mode, the user can continue set other
modes or back from the setting mode.
