A S S E M B LY I N S T R U C T I O N S
L O A D I N G C A R T R I D G E S
Input
Tray
Remove the XM1255, crank handle assembly and hex wrench from the packaging.
1.
Place the Crank Handle assembly
onto the D-shaped roller shaft with
the set screw facing upward.
2.
Move the handle forward on the
D-shaped shaft until it stops.
3.
Use the Hex wrench to secure the
set screw.
Step 1:
Slide input tray out of machine
by pressing tabs on each side.
Step 3:
From the input side, insert starter
card into machine between
the substrates to start material
through the rollers. Turn
the handle of
the machine
in a cloclwise
direction. This
will advance
the material.
Step 4:
Advance the film through the
machine until the film is aligned
and wrinkle free. This may take
6-10 inches. Reinsert the tray. Be
sure it “snaps” into place.
Step 2:
With top cover open, lift out used
cartridge completely. Replace cartridge
with new one.
Make sure
label is up and
viewable from
top input
side of
machine.
Step 5:
Press down the orange blade holder and
slide it in either direction to trim excess film.
