AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
AA
Connection to ProDIGITAL Handheld
The ProSwap Logger is designed to interface with the
ProSwap Handheld and ProDSS Handheld meters.
1.
Align the keys on the cable connector with the slots
on the handheld connector.
2.
Push together firmly, and then twist the outer ring
clockwise until it locks into place.
3.
Power on the handheld to calibrate and set up for
logging.
The handheld connection provides power to the
ProSwap Logger. Loggers with internal battery may be
charged via this connection.
Sensor Installation
The ProSwap Logger includes built-in temperature and
depth sensors in addition to a single port. The port will
allow any ProDSS smart sensor to be connected.
1.
Remove the port cover shipped with the cable.
2.
Apply a thin coat of lubricant to the sensor o-rings.
3.
Carefully align the sensor and bulkhead connectors
by inserting the sensor into the port then gently
rotating the sensor until the connectors align. Once
aligned, push the sensor toward the bulkhead until
the sensor seats in the port.
4.
Finger-tighten the retaining nut clockwise. If
any resistance is felt, loosen the retaining nut
completely to prevent cross-threading.
5.
Use the sensor installation tool to tighten the
retaining nut clockwise until snug. Be careful not to
over-tighten the retaining nut.
6.
Install the probe guard.
3
